• Benvenuti su RaspberryItaly!
Benvenuto ospite! Login Login con Facebook Registrati Login with Facebook


Valutazione discussione:
  • 0 voto(i) - 0 media
  • 1
  • 2
  • 3
  • 4
  • 5

[-]
Tags
pt100 sonda

Sonda pt100
#1
Buon giorno ragazzi

Chi mi può dare una mano, devo installare una pt100 nel raspberry e leggere la temperatura con il software craftbeerpi
Risposta
#2
web.craftbeerpi.com/hardware Ha scritto:CraftBeerPi is supporting DS18B20 temperature sensors. Theses sensors are connected via a 1-Wire bus. The bus can handle up to 10 temperature sensors. The sensors are put into a Stainless Steel Thermowell with ½” BSP or NPS fitting. By default the GPIO4 is used for the 1-Wire Bus. Between GPIO4 pin and 3V pin a 4,7k Ohm resistor need to place. All temp sensors are connected parallel. Each sensor needs to be connected with three wires: GND, DATA and VDD

Non sembra supportare nativamente la pt100.. Prova però a collegarla
Risposta
#3
(08/08/2018, 21:14)Zzed Ha scritto:
web.craftbeerpi.com/hardware Ha scritto:CraftBeerPi is supporting DS18B20 temperature sensors. Theses sensors are connected via a 1-Wire bus. The bus can handle up to 10 temperature sensors. The sensors are put into a Stainless Steel Thermowell with ½” BSP or NPS fitting. By default the GPIO4 is used for the 1-Wire Bus. Between GPIO4 pin and 3V pin a 4,7k Ohm resistor need to place. All temp sensors are connected parallel. Each sensor needs to be connected with three wires: GND, DATA and VDD

Non sembra supportare nativamente la pt100..  Prova però a collegarla



in teoria basta scaricare questo aggiornamento e mettere un max31865


Allegati Anteprime
   
Risposta
  


Vai al forum:


Navigazione: 1 Ospite(i)
Forum con nuovi Post
Forum senza nuovi post
Forum bloccato
Forum Redirect