Questo forum utilizza i cookies
Questo forum fa uso di cookie per migliorare l'esperienza utente. I cookie sono piccoli file di testo memorizzati sul tuo browser. I cookie impostati dal forum possono essere utilizzati solo su questo sito e non costituiscono rischio per la sicurezza, vengono utilizzati unicamente per memorizzare le tue preferenze. Navigando sul sito accetti che RaspberryItaly installi i cookie sul tuo browser.
Per maggiori informazioni consulta l'informativa sui Cookie di RasberryItaly

Un cookie verra memorizzato nel browser indipendentemente dalla scelta per evitare che questa domanda ti venga posta di nuovo. Sarai in grado di modificare le impostazioni dei cookie in qualsiasi momento utilizzando il link nel footer.
  • Benvenuti su RaspberryItaly!
Benvenuto ospite! Login Login con Facebook Registrati Login with Facebook


Valutazione discussione:
  • 0 voto(i) - 0 media
  • 1
  • 2
  • 3
  • 4
  • 5

[-]
Tags
pt100 sonda

Sonda pt100
#1
Buon giorno ragazzi

Chi mi può dare una mano, devo installare una pt100 nel raspberry e leggere la temperatura con il software craftbeerpi
Risposta
#2
web.craftbeerpi.com/hardware Ha scritto:CraftBeerPi is supporting DS18B20 temperature sensors. Theses sensors are connected via a 1-Wire bus. The bus can handle up to 10 temperature sensors. The sensors are put into a Stainless Steel Thermowell with ½” BSP or NPS fitting. By default the GPIO4 is used for the 1-Wire Bus. Between GPIO4 pin and 3V pin a 4,7k Ohm resistor need to place. All temp sensors are connected parallel. Each sensor needs to be connected with three wires: GND, DATA and VDD

Non sembra supportare nativamente la pt100.. Prova però a collegarla
Risposta
#3
(08/08/2018, 21:14)Zzed Ha scritto:
web.craftbeerpi.com/hardware Ha scritto:CraftBeerPi is supporting DS18B20 temperature sensors. Theses sensors are connected via a 1-Wire bus. The bus can handle up to 10 temperature sensors. The sensors are put into a Stainless Steel Thermowell with ½” BSP or NPS fitting. By default the GPIO4 is used for the 1-Wire Bus. Between GPIO4 pin and 3V pin a 4,7k Ohm resistor need to place. All temp sensors are connected parallel. Each sensor needs to be connected with three wires: GND, DATA and VDD

Non sembra supportare nativamente la pt100..  Prova però a collegarla



in teoria basta scaricare questo aggiornamento e mettere un max31865


Allegati
.png   pt100.PNG (Dimensione: 7.61 KB / Download: 7)
Risposta
  


Vai al forum:


Navigazione: 1 Ospite(i)
Forum con nuovi Post
Forum senza nuovi post
Forum bloccato
Forum Redirect